SIGRITY Unified Package Designer
Basic Training
Learn to create BGA Packaging designs using Sigrity's UPD application.
The objective is to complete a small BGA demo design during the labs. This
class offers an overview of the Unified Package Designer (UPD) system and BGA
process technologies, from library creation to outputs. The course is
structured in a lecture/lab style, allowing students maximum on-system
practice. Terminology and general design strategies are covered along with
automatic wire bonding, automatic routing and complex geometries.
Course Objectives
Learn UPD GUI menus system/storage
Create library objects for each design
Create design setup preference, rules, and netlist
Create geometry objects, rings, gate metal areas
Generate wire bonding
Use all auto routes and manual trace editor
Check all design rules
Finalize the design, create teardrops, documentation, reports and
listing
Output your design using Gerber, DXF, DSII, and DRILL
Complete a small BGA wire bonded design
Course Outline
The course is 3 days (approximately 9:00AM to 5:00PM each day).
Day One Introduction to the user interface
Design settings and preferencesSubstrate
Layers
Padstacks
Die/packagesDesign rules
Net list
Figures
Day Two
Contour areafillDesign flags and rings
Wire bonding
Routing
Via patterns
Differential nets
Layer parasitic
Net management
Auto-routing
Design Checking
Day Three Beautify your designSoldermask
Documentation layers
Plating bar/traces
Teardrops/tapers
Board text
Bond naming
Reports and listings
Reports and listings
Gerber, DXF, Drill, GDSII output
Laptop System
Requirements
Note:
You must bring your own laptop unless you have made
pre-arrangements with SIGRITY.
Unified Package
Designer Basic Training
P2-266 processor (minimum) -- Recommended at least 2.0 GHz.
256MB (minimum) -- Recommended 512MB.
4-5GB Total Disk space.
XGA Graphics (1024x768 minimum resolution).
Network Protocol: TCP/IP
Media: CD-ROM
NT 4.0
Windows 2000
XP
|
